Hello all,
I found the the Fermi energies from SCF, Fermi surface, DOS calculation are a bit different. Then my question is Why all the Fermi energies are not identical for the same system, which one should I use? Thanks a lot.
Zjuer
Fermi level
Moderator: bguster
-
wenzhouchen
- Posts: 3
- Joined: Thu Sep 08, 2011 2:55 pm
Re: Fermi level
Hellow,
The Fermi energy can get from the output file, but i want to know how do you gt the Fermi surface?
The Fermi energy can get from the output file, but i want to know how do you gt the Fermi surface?
Re: Fermi level
To get the Fermi surface in BXSF format (for XCrysDen), you can use the prtfsurf variable. However, you can only it with a non-shifted k-grid.
The 3 different Fermi levels you get are probably due to different k-grid. You need a very dense k-grid in a metal because of the Fermi surface (this is more important in some system than in others). I think you should use the Fermi levels from the calculation with the most k-points. If the difference between the three values is significant, you should consider rerunning the calculations with more k-points.
Simon
The 3 different Fermi levels you get are probably due to different k-grid. You need a very dense k-grid in a metal because of the Fermi surface (this is more important in some system than in others). I think you should use the Fermi levels from the calculation with the most k-points. If the difference between the three values is significant, you should consider rerunning the calculations with more k-points.
Simon