ABINIT Discussion Forums

Is there any difference betwee the phonon band calculated by trf2_1.in and teph_1.in?
I mean , in trf2_1.in , I just got the phonon band structures
but in teph_1.in I got both the phonon band structures and the el-ph information because this calculation takes the el-ph interaction into consideration,
Is that possible to get two different sets of phonon band structres if I use the same set of parameters in trf2_1.in and teph_1.in?

Thank you very much
Shao

If you use the same parameter as teph*.in for trf2*.in then you would get an el-ph results. The data that you get is only dependent on the content (Parameters) of the *.in file and not on its name.