Due to the error code or machine? [SOLVED]
Posted: Fri Mar 20, 2015 11:06 am
Dear Abinit's users
I run an Abinit calculation on a monoclinic structure with 12 atoms, low cutoff energy (10 hartree), low number of k points and one SCF iteration, the code runs, but when I increase these parameters, the code stops at the first iteration leaving the message error:
Thanks for all.
I run an Abinit calculation on a monoclinic structure with 12 atoms, low cutoff energy (10 hartree), low number of k points and one SCF iteration, the code runs, but when I increase these parameters, the code stops at the first iteration leaving the message error:
Code: Select all
=====================================================================================
= BAD TERMINATION OF ONE OF YOUR APPLICATION PROCESSES
= EXIT CODE: 11
= CLEANING UP REMAINING PROCESSES
= YOU CAN IGNORE THE BELOW CLEANUP MESSAGES
=====================================================================================
APPLICATION TERMINATED WITH THE EXIT STRING: Segmentation fault (signal 11)Thanks for all.
Cu3Alnstep2.log- log file with nstep =2 (>1)
- (89.31 KiB) Downloaded 327 times