Sirs
I try to run a test, and enter this command (mpirun - np 45 abinit < tbase3_x.files > log 2> err
), but it does not run. It gives me an empty err & Log file.
Could you please send me the correct command to run properly
Thanks
Hameed
Command & Terminal [SOLVED]
Moderators: fgoudreault, mcote
Forum rules
Please have a look at ~abinit/doc/config/build-config.ac in the source package for detailed and up-to-date information about the configuration of Abinit 8 builds.
For a video explanation on how to build Abinit 7.x for Linux, please go to: http://www.youtube.com/watch?v=DppLQ-KQA68.
IMPORTANT: when an answer solves your problem, please check the little green V-like button on its upper-right corner to accept it.
Please have a look at ~abinit/doc/config/build-config.ac in the source package for detailed and up-to-date information about the configuration of Abinit 8 builds.
For a video explanation on how to build Abinit 7.x for Linux, please go to: http://www.youtube.com/watch?v=DppLQ-KQA68.
IMPORTANT: when an answer solves your problem, please check the little green V-like button on its upper-right corner to accept it.
-
hameed1987
- Posts: 41
- Joined: Sat Jun 22, 2019 12:45 pm
- Location: The UK
Command & Terminal
Dear All,
WR
Hameed
WR
Hameed
Re: Command & Terminal
What happens when you try the following command?
Code: Select all
abinit < tbase3_x.filesNicholas A. Pike
Research Scientist
Research Scientist
-
hameed1987
- Posts: 41
- Joined: Sat Jun 22, 2019 12:45 pm
- Location: The UK